Delay & Reverb Programs - Yamaha R100 Bedienungsanleitung

DELAY $ REVERB PROGRAMS
he DELAY & REVERB effects provided combine the R100's superb reverb sound with delays in a number of fas
cinating ways. In programs 11 through 14 the reverberation and delays are integrated in a way that allows varying the
number of delay repeats produced.
PARAMETER 1: Effect/Direct Signal Balance
e Range: 0 — 99
Adjusts the balance between the direct sound of your in-
- strument (or other source) and the effect signal. At "99"
only the effect sound is delivered from the R100 outputs,
while at "0" only the direct sound is output. At a setting
of "50," the direct and effect sounds are output in ap-
proximately equal proportions.
PARAMETER 2: Delay
e Display Range: 0 — 99
e Corresponding Delay Range: 0.1 — 150 milliseconds
This parameter represents the delay between the direct
sound of an instrument and a number of repeats deter-
mined by the setting of the Feedback Gain \ parameter
(below).
DELAY + REVERB PROGRAMS
PARAMETER 3: Feedback Gain
е Range: 0 — 99
Sets the amount of the delay signal fed back to the input
of the processor. The higher the feedback gain setting, the
greater the number of delayed repeats produced,
PARAMETER 4: Reverb Time
e Display Range: 0 — 99
e Corresponding Reverb Time Range: 0.3 — 99.0 sec-
onds
Determines the length of the reverb sound produced at
each of the program's delayed répeats.
n programs 15 through 20 the left- and right-channel delays are independently pro grammable. The delays are used to
manipulate the reverb sound to create a range of unique effects that can be used to add interesting variations to your
music.
PARAMETER 1: Effect/Direct Signal Balance
e Range: 0 — 99 | |
Adjusts the balance between the direct sound of your in-
strument (or other source) and the effect signal. At "99"
only the effect sound is delivered from the R100 outputs,
while at "0" only the direct sound is output. At a setting
of "50," the direct and effect sounds are output in ap-
proximately equal proportions.
PARAMETER 2: Left Channel Delay
e Display Range: 0 — 99
е Corresponding Delay Range: 0.1 — 150 milliseconds
Sets.the time between the repeats heard from the left
channel.
PARAMETER 3: Right Channel Delay
e Display Range: 0 — 99
+ Corresponding Delay Range: 0.1 — 150 milliseconds
Sets the time between the repeats heard from the right
- channel.
PARAMETER 4: Reverb Time
Determines the length of the reverb sound produced at
each of the program's delayed repeats.