Parkside PASA 20-Li A1 Installationsanleitung Seite 21

Attention! An up-to-date list
of battery compatibility can
be found at:
www.lild.de/akku
The device is part of the Parkside X 20 V
TEAM series and can be operated with
batteries of the Parkside X 20 V TEAM
series.
Batteries of the Parkside X 20 V TEAM
series may only be charged using chargers
of the Parkside X 20 V TEAM series.
We recommend that you operate this appli-
ance with the following batteries only:
PAP 20 A1, PAP 20 A2, PAP 20 A3,
PAP 20 B1, PAP 20 B3.
We recommend charging these batteries
with the following chargers: PLG 20 A1,
PLG 20 A3, PLG 20 A4, PDSLG 20 A1.
PLG 20 A1
Charging
time (min. PLG 20 A4
PAP 20 A1
60
PAP 20 B1
PAP 20 A2
90
PAP 20 A3
120
PAP 20 B3
Levels of noise and vibration were determi-
ned according to the standards and regula-
tions in the declaration of conformity.
The specified total vibration values and the
stated noise emission values have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specified total vibration values and the
stated specified noise emission values can
also be used for a provisional assessment
of the load.
PLG 20 A3
PDSLG 20 A1
35
45
60
Warning: The vibration and noise
emissions may deviate from the
specified values during actual use of
the power tool, depending on how
the power tool is being used and, in
particular, what kind of material is
being worked on.
Try to keep the exposure to vibrati-
ons and noise as low as possible.
Examples of measures to reduce
exposure are the wearing of gloves
when using the tool and limiting the
working hours. All parts of the ope-
rating cycle have to be considered
while doing so (for example, times
when the power tool is switched off
and times when it is switched on but
running without any load).
Safety information
This section describes the basic safety rules
when working with the device.
Symbols used in the
instruction manual
Hazard symbols with in-
formation on prevention of
personal injury and property
damage.
Precaution symbol with information
on prevention of harm / damage.
Wear gloves when handling the
saw blade.
Notice symbol with information on
how to handle the device properly.
GB MT
21