Flowchart
MAN Setting
D
Temperature
Protection
D
R
Brake Off
Time from motor cut-off until (dead time) brake activation. By means of push-
buttons L-R setting between 0-7s is possible.
Initial braking level in %.By means of push-buttons L-R setting between 0-80%
is Initial Brake possible
Final braking level in %. Setting by push-buttons L-R Final Brake
Speed of braking (time between the begin of braking and attainment of the
preset final braking effekt). Brake Speed The time is set by push-buttons L-R
If during initial selection we choose BRAKE OFF then we proceed further from
the line TIMING OPERATION MODE AIRCRAFT with push-button R for the
Heli mode setting.
Setting for model helicopters
without constant speed
regulation
D
R
Operation mode
Aircraft
D
Jump to position
TIMING
Certain parameters of the controller can be set or checked manually.
With the aid of push-buttons L-R the level of the controller temperature protection can be set.
Redefined brake:
The first value is the initial braking level in %, the second value – the
final braking level in %, the third value – time of brake application
between the first and second intensity. Confirm brake setting with
push-button D.
If the brake is switched off jump to line OPERATION MODE –
switching between modes Aircraft-Helicopter.
R
Soft Brake
Heli normal
Setting of motor pole numbers of Helicopters by means of push-
buttons L-R
R
Medium Brake
Setting for helicopters with
speed regulation
R
Heli const. RPM
ID # 0058019
R
Hard Brake
Setting for competition flying
with constant speed regulation
R
Heli const. RPM
3D
Flowchart
Brake Manual
Setting
D
Dead Time
D
Initial Brake
D
Final Brake
D
Brake Speed
D
Jump to position
TIMING
D
Motor Pole No
19