Herunterladen Diese Seite drucken

Husqvarna DUAL PURPOSE TE 610 2019 Betriebsanleitung Seite 54

Werbung

rio ricaricare la batteria. Avviato il
motore, cessa il controllo della
batteria e si attiva il contagiri)
10 a+10 b: Indicatori "LED" VER-
TICALE ed ORIZZONTALE
"CONTAGIRI" (attivi entrambi
una volta avviato il motore: la
posizione di fondo corsa indica
un regime di ca. 8250 giri/1')
: in caso di accensione della
*
spia, decelerare IMMEDIATA-
MENTE per evitare di DANNEG-
GIARE IL MOTORE.
Durante i primi 1500 km, non
superare MAI i 5500 giri/1'.
41I
cator is on when the ignition key
is on IGNITION position and the
engine is stopped; if the battery
charge is below the middle hei-
ght of the indicator, charge
the battery. When the engine
starts, the indicator stops the
battery check and starts the
tachometer running)
10 a+10 b: Vertical and horizon-
tal "LED" indicators "TACHOME-
TER" (both indicators are on
when engine starts: the end of
the indicators stroke shows 8250
r.p.m.)
: if the warning light comes on,
*
IMMEDIATELY decelerate in
order to avoid ENGINE DAMA-
GES. During first 1500
km, NEVER exceed 5500 r.p.m
de recharger la batterie. Ache-
miné le moteur, il eux cesse le
contrôle de la batterie et il active
le compte-tours)
10 a+10 b: Indicateurs» LED»
VERTICAL et HORIZONTAL»
COMPTE-TOURS» (actifs les
deux une fois acheminée le
moteur: la position de fond cour-
se indique un régime de ca. 8250
giri/1')
: en cas d'allumage de le
*
voyant, décélérer IMMÉDIATE-
MENT pour éviter d'ENDOMMA-
GER LE MOTEUR. Pendant
les premier 1500 kms, ne pas
dépasser jamais les 5500
tours/1.'
10- Anzeigende " LED" (SENK-
RECHT und WAAGERECHT)
10 a: Anzeigende" LED", SENK-
RECHT, "BATTERIELADUNG"
(Kontrolleuchte betätigt mit dem
Schlüssel von Zündung in Posi-
tion IGNITION, mit ausgeschalte-
ter Motor; wenn das Amt der
Batterie kein die Hälfte von den
Anzeiger überwindet, ist es
notwendig, wieder die Batterie
aufzuladen. Startet den Motor, es
beendet die Kontrolle der Batte-
rie und es fängt mit dem Funktio-
nieren des Drehzahlmessers an)
10 a+10 b: Anzeigende" LED"
(SENKRECHT und WAAGERE-
CHT) "DREHZAHLMESSER" (die
Anzeiger sind beide Aktivbe-
stand, nachdem der Motor
gestartet wurde: die Position
zeigt von Boden Lauf auf ein
Regime des Motors von etwa
8250 Drehungen zur Minute)
: bei Zündung des Kontrolleu-
*
chte, UNVERZÜGLICH verlang-
samen um zu vermeiden DEM
MOTOR Schaden.
Während die ersten 1500 km,
NIE die 5500 giri/1 überwinden.

Werbung

loading

Diese Anleitung auch für:

Dual purpose sm 610 2019