Herunterladen Diese Seite drucken

Husqvarna DUAL PURPOSE TE 610 2019 Betriebsanleitung Seite 40

Werbung

INTERRUTTORE ACCENSIONE,
SPIE INDICATRICI, STRUMENTI
(Fig. 5)
L'interruttore di accensione con-
sta di tre posizioni. Dalla posizio-
ne OFF, girare la chiave (1) in
senso destrorso; nella prima
posizione IGNITION si avranno
inseriti l'accensione e gli utilizza-
tori, nella seconda posizione si
avranno inserite le luci di par-
cheggio. La chiave può essere
estratta soltanto nella posizione
OFF e quando sono inserite le
luci di parcheggio. In caso di
smarrimento di una delle due
chiavi, approntarne un'altra utiliz-
zando la chiave GREZZA che
viene fornita a ricambio. Il moto-
ciclo è equipaggiato con uno
strumento digitale. Inizialmente,
ruotando la chiave di accensione
in posizione IGNITION, viene
effettuata una VERIFICA GENE-
RALE (A) dello strumento. Le
opzioni, che si possono selezio-
nare nell'ordine, sono le seguenti:
1- DEFAULT: visualizza batteria,
velocità istantanea e totalizza-
tore km o miglia percorsi
2- TRP: visualizza velocità istan-
tanea e totalizzatore parziale
3- CLK: visualizza velocità istan-
tanea e orologio
4- rpm: visualizza velocità istan-
tanea e giri motore
36
IGNITION SWITCH, WARNING
LIGHTS INSTRUMENTS
(Fig. 5)
The ignition switch has three
positions:
From position OFF turn the key
(1) rightwards; in the first IGNI-
TION position the start and the
instruments will be on; in the
second position the parking
lights will be on. The key can be
extracted when in OFF position
only and when the parking lights
are on. If you mislay one of the
ignition switch keys, use the
BLANK key supplied by Husqvar-
na to obtain another one.
The motorcycle is equipped with
a digital instrument.
Initially, turning the ignition key
on IGNITION position, a GENE-
RAL CHECK (A) of the instru-
ment is done.
The instrument settings are the
following, and in the order
shown:
1- DEFAULT: shows battery,
instant speed and total odo-
meter (covered kilometers or
miles)
2- TRP: shows instant speed and
partial odometer
3- CLK: shows instant speed and
clock
4- rpm: shows instant speed and
engine r.p.m.
COMMUTATEUR DE DEMARRA-
GE, VOYANT, INTSTRUMENTS
(Fig. 5)
Le commutator de démarrage à
trois positions:
En position OFF, tourner la clé (1)
en sens horaire; dans la première
position IGNITION, seront
insérés le démarrage et les
instruments; dans la deuxième
position, seront insérés les feux
de stationnement. La clé peut
être enlevée seulement en posi-
tion OFF et lorsque sont insérés
les feux de stationnement. En
cas d'égarement d'une des deux
clés, en dresser une autre au
moyen de la clé BRUTE fournie
par Husqvarna. Le motocycle est
équipé avec un instrument digi-
tal. Initialement, en tournant la
clé d'allumage en position IGNI-
TION, elle est effectuée une
VÉRIFICATION GÉNÉRAL (A) de
l'instrument. Les options, qu'ils
peuvent sélectionner dans
l'ordre, sont les suivante:
1 - DEFAULT: il visualise batterie,
vitesse instantanée et totalisa-
teur km ou milles parcourus
2 - TRP: il visualise vitesse instan-
tanée et totalisateur partiel
3 - CLK: il visualise vitesse
instantanée et montre
4 - rpm: il visualise vitesse instan-
tanée et tu tournes moteur
ZÜNDSCHALTER - KONTROL-
LEUCHTEN INSTRUMENTE
(Bild 5)
Der Zündschalter hat drei Stellun-
gen:
Befindet sich der Schlüssel (1) auf
OFF, muss er nach rechts gedreht
werden; in der ersten Stellung,
IGNITION, sind Zündung und Hilf-
sapparate eingeschaltet; bei der
zweiten Stellung sind Parklichter
eingeschaltet. Der Schlüssel kann
nur abgezogen werden, wenn er
sich bei der OFF Stellung befindet
und wenn die Parklichter einge-
schaltet sind. Sollten Sie einer der
beiden Schlüssel verlieren, lassen
Sie mit dem von der Husqvarna
gelieferten ROHSCHLÜSSEL
einen anderen anfertigen. Das
Motorrad wird mit einem Digital-
Instrument ausgerüstet. Anfängli-
ch wird eine GENERAL PRÜ-
FUNG (A) des Gerätes ausgeführt,
von schwingt es im Kreise den
Schlüssel von Zündung in der
Position IGNITION. Die Optionen,
auswählbar in diese Bestellung,
sind sie die folgenden:
1- DEFAULT: es veranschaulicht:
Batterie, augenblickliche Sch-
nelligkeit und Totalisator km
oder legten Meilen
2- TRP: es veranschaulicht:
augenblickliche Schnelligkeit
und Teil Totalisator
3- CLK: es veranschaulicht: augen-
blickliche Schnelligkeit und Uhr
4- rpm: es veranschaulicht:
augenblickliche Schnelligkeit
und Nummer von Drehungen
des Motors

Werbung

loading

Diese Anleitung auch für:

Dual purpose sm 610 2019