Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. AUTOMATIC CLEANING
• Click „Auto" on the main screen to start
cleaning.
1
• The vacuum cleaner systematically scans
all rooms in the map where it is granted
access and cleans them according to the
selected settings. It then returns to the
charging station.
NOTES:
• It is one of the most usable cleaning modes, when the vacuum
cleaner cleans up the whole available area.
• Automatic cleaning is also being used for the primary creation of a map.
• If the battery runs out during cleaning, the robot will continue where
it left off after charging.
7. ROOM CLEAN-UP
• To start cleaning, click on „Room"
on the main screen.
• Then click on one or more rooms you want
to clean. The selected rooms will
1
be colored.
• Then click the
„Go Here
cleaning.
• After cleaning, the vacuum cleaner
automatically returns to the charging station.
8. AREA CLEANING
1
2
NOTES:
• You can set up to 8 different zones for zone cleaning.
" button to start
• The vacuum cleaner will clean all the zones created during zone
cleaning.
• Click „Zone" on the main screen to start
cleaning.
• On the right side of the screen, 2 buttons
have been made available -
„x
1", which
can be used to select how many times the
robot should vacuum a given zone, and
„+
1
Sweep
area", which can be used to insert
individual zones into the map.
• The zone can be moved and resized on
the map with your finger.
• If you want to remove a zone, click directly
on it with a finger and then click on „x".
NOTES:
• Within local cleaning, the vacuum cleaner cleans a square around
• Then click on the
„Go Here
" button
to start cleaning.
• After cleaning, the vacuum cleaner
automatically returns to the charging
station.
1
REMARKS:
• To use the mopping function, the mopping attachment must be
• When using the mopping function, the vacuum cleaner must be
• function.
9. LOCAL CLEANING
• Click „Local" on the main screen to start
cleaning.
• Click on a place in the map with a finger,
where you want to perform local cleaning.
The point around of which local cleaning is
to be performed will be shown in the map.
• Then click on the
„Go Here
to start cleaning.
• After cleaning, the vacuum cleaner
automatically returns to the charging
station.
the set point with sizes of 1 x 1 m.
10. CLEANING AND MOPPING PARAMETERS
• On the main screen, click to open the
„Setting
" menu (bottom right corner).
• Several setting options will appear
cleaning:
1)
Watter quantity
the option to turn mopping off.
2)
Suction power
power during vacuuming.
3)
Dynamic boost
used to activate (
the increase in suction power when the
robot detects a carpet.
installed in the vacuum cleaner according to the instructions for use.
prevented from hitting the carpet - ideally by using the Evade zone
ENG
" button
during mopping with
- setting the suction
- The switch can be
) or deactivate (
)
ENG - 38
Werbung
Inhaltsverzeichnis
