Cleaning And Maintenance; Accessories - eta ADAGIO Bedienungsanleitung

REPLACEMENT OF OUTPUT FILTERS
To remove the output filters, follow the procedure indicated in Fig. 4. To fit new output filters
in the vacuum cleaner, proceed in reverse order.
VI. CLEANING AND MAINTENANCE
– Maximum suction performance can be achieved when the filters are clean and the
dustbag is empty.
– When you have replaced the dustbag about five times, the filters need to be cleaned,
or replaced.
– When you are vacuuming very fine dust, the dustbag and filter pores might get
clogged. This reduces the air flow and deteriorates the suction performance.
In such a case, the dustbag needs to be replaced as soon as possible (even though
it might not be full yet) and the filters must be cleaned or replaced.
– Used dustbags and filters are to be disposed of with regular household waste.
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents!

Accessories

After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Cleaning the TURBO nozzle C2
Cut the threads and hairs with scissors. Turn on the vacuum cleaner. The cleaner vacuums
the cut hairs and threads. In case hairs or threads got tangled up around the attachment of
the brush cylinder and cannot be removed with the above-mentioned steps, it is necessary to
remove them with a suitable tool (e.g. tweezers).
Input and output filters
Rinse the filter (A12, A15) under running water. Allow them to dry out properly before their
re-use. Shake out the input HEPA filter A14 gently, or blow it out. If the HEPA filter is very
dirty, you can rinse it under running lukewarm water. Allow it to dry out properly.
– If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter
cannot be washed more than three times. After that, a new filter needs to be purchased.
– We recommend that you replace the HEPA filter twice a year. The other filters are to
be replaced if they cannot be properly cleaned any more, or if they are damaged.
– If the filters are not cleaned or replaced, it might result in damaging the vacuum cleaner!
Other parts
Clean the telescopic suction tube C12, suction hose C11 and grids A11, A13 with a wet cloth.
Allow all the parts to dry out properly before re-use.
Caution
Caution
25 / 45
GB