Cleaning And Maintenance; Environmental Protection - eta Stellar Bedienungsanleitung

GB
DUST CONTAINER REMOVAL
When taking out and disassembling the dust container B follow the procedure indicated
in Fig. 4. Dispose of dirt contained in the dust container with regular household waste. An
emptied and cleaned container is to be put back into the vacuum cleaner in reverse order.
INPUT FILTERS REPLACEMENT
To remove the input filters, follow the procedure indicated in Fig. 4. To fit a new input filter in
the vacuum cleaner, proceed in reverse order.
OUTPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 3. To fit a new output filter
in the vacuum cleaner, proceed in reverse order.
VI. CLEANING AND MAINTENANCE
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents!
Accessories
After any vacuuming it is recommended to check visually the brushes or collectors
for possible impurities. If there are some impurities, remove them.
Dust container
Clean the surface and the inside of the container B with a soft wet cloth. Rinse the separator
B7, B13 part and the seal under running water. Allow all the parts to dry out properly before
their re-use.
Input and output filters
Rinse the filter B6, B10 under running water. Allow them to dry out properly before their
re-use. Shake out the input HEPA filter (A9, B5) gently, or blow it out. If the HEPA filter
is very dirty, you can rinse it under running lukewarm water. Allow it to dry out properly.
– Do not clean the HEPA filters or the other filters with any aggressive washing
or cleaning detergents or hot water.
– In order to maintain the filtering parameters of the HEPA filters, we recommend that you
use a dry method of cleaning.
– If you clean the HEPA filters with water, its filtration properties will deteriorate. The filter
cannot be washed more than three times. After that, a new filter needs to be purchased.
– If the filters are not cleaned or replaced, it might result in damaging the vacuum cleaner!
Other parts
Clean the telescopic suction tube C8 and suction hose C6 with a wet cloth. Allow all the
parts to dry out properly before re-use.
VII. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified on
the product or in the accompanying documentation mean that the used electrical or electronic
products must not be disposed of together with municipal waste. For proper disposal of the
product, hand it over at special collection places where it will be taken over free of charge.
Caution
20 / 38