Cleaning And Maintenance; Accessories - eta ETA051790000 Bedienungsanleitung

DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 4. Dispose of
dirt contained in the dust container with regular household waste. An emptied and cleaned
container is to be put back into the vacuum cleaner in reverse order.
INPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 4. To fit a new input filter
in the vacuum cleaner, proceed in reverse order.
OUTPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 3. To fit a new output filter
in the vacuum cleaner, proceed in reverse order.
VI. CLEANING AND MAINTENANCE
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents!

Accessories

After any vacuuming it is recommended to check visually the brushes or collectors
for possible impurities. If there are some impurities, remove them.
Cleaning the TURBO nozzle C3 (Fig. 8)
Cut the threads and hairs with scissors. Turn on the vacuum cleaner. The cleaner vacuums
the cut hairs and threads. In case hairs or threads got tangled up around the attachment of
the brush cylinder and cannot be removed with the above-mentioned steps, it is necessary
to remove them with a suitable tool (e.g. tweezers). For simpler and more comfortable
maintenance, remove the upper cover by releasing the locking latches on the sides. At the
same time, make sure no dirt is stuck on the inner side of the nozzle (i.e. turbine). Release
the two arrest latches on the bottom side of the nozzle in the direction of the arrow and
remove the cover. Clean the space with a suitable tool (e.g. tweezers). Insert the covers back
into the nozzle reversely and close it with by folding it up (you hear an audible click).
Dust container
Clean the dust container with a wet cloth. Allow all the parts to dry out properly before re-use.
Input and output filters
Rinse the filter B4, B5, B7 under running water. Allow them to dry out properly before their
re-use. Shake out the HEPA filter A11 gently, or blow it out. If the HEPA filter is very dirty, you
can rinse it under running lukewarm water. Allow it to dry out properly.
– Do not clean the HEPA filter or the other filters with any aggressive washing
or cleaning detergents or hot water.
– In order to maintain the filtering parameters of the HEPA filter, we recommend that
you use a dry method of cleaning.
– If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter
cannot be washed more than three times. After that, a new filter needs to be purchased.
– If the filters are not cleaned or replaced, it might result in damaging the vacuum cleaner!
Other parts
Clean the telescopic suction tube C11 and suction hose C10 with a wet cloth. Allow all the
parts to dry out properly before re-use.
Caution
27 / 50
EN