Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING TIMES
Set power
MIN
MAX
* Note: The stated operating times are based on ETA's internal testing and only apply
to a new and fully charged battery. Depending on the age and wear of the battery, the
operating time decreases.
INSTALLING THE CHARGING STAND ON THE WALL
To install the charging stand D on the wall, use the holes D2 on its back. Mount the charging
stand D on the wall using a suitable connecting material.
– Make sure that the electric socket is sufficiently close to the mounted stand.
– Check that there is no electrical, telephone, water or other similar installation in
the wall at the place of the mounting of the stand.
IV. USE OF VACUUM CLEANER
Let the vacuum cleaner charge sufficiently prior to using.
CONTROL
ON/OFF button (A1)
Suction power control (A2)
when pressed once
when pressed twice
V. REMOVING THE DUST CONTAINER AND FILTER
DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 1. Dispose of
dirt contained in the dust container with regular household waste. An emptied and cleaned
container is to be put back into the vacuum cleaner in reverse order.
REPLACING THE HEPA FILTER
When removing the HEPA filter, proceed according to Fig. 1. Insert the new/clean HEPA
filter into the vacuum cleaner in a reverse order.
VI. CLEANING AND MAINTENANCE
– The maximum suction effect can only be achieved with a clean HEPA filter and an
empty dust container.
– We recommend cleaning the HEPA filter each time when the dust container is emptied.
– When vacuuming very fine dust, the HEPA filter pores may become clogged, which
reduces air permeability and the suction performance. In this case, it is required to
clean the HEPA filter even when the tank is not full.
Running Time *
ETA1425
Approx. 25 minutes
Approx. 17 minutes
Warning
- vacuum cleaner ON/OFF switch
- high suction power
- low suction power
Warning
23 / 46
GB
ETA2425
Approx. 30 minutes
Approx. 20 minutes
Werbung
Inhaltsverzeichnis
