Removing The Dust Container And Filter; Cleaning And Maintenance - eta ETA244990000 Bedienungsanleitung

USING THE MOP ATTACHMENT (F)
1. Fill the mop attachment F with water through the filling openings F4 (max 150 ml).
2. Select an appropriate mop pad (F1, F2, F3) to suit the floor type.
3. When filled and assembled, fit the mop attachment to the floor nozzle E (Fig. 1, 4).
4. Mop the floor with smooth movements.
– The mop attachment can be used while vacuum cleaning is on or off. If you are
mopping and vacuuming at the same time, first move the vacuum cleaner forwards on
the surface you are cleaning and then return using the same path you have already
vacuumed and cleaned. This will ensure the proper sequence of the cleaning process
- vacuum cleaning to get rid of any dirt first, followed by floor mopping.
– Do not use/pour any detergent in the mop water tank.
– With the mop attachment you can mop an area of up to 40 m
V. REMOVING THE DUST CONTAINER AND FILTER
DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 1. Dispose of
dirt contained in the dust container with regular household waste. An emptied and cleaned
container is to be put back into the vacuum cleaner in reverse order.
REPLACING THE HEPA FILTER
When removing the HEPA filter, proceed according to Fig. 1. Insert the new/clean HEPA
filter into the vacuum cleaner in a reverse order.
VI. CLEANING AND MAINTENANCE
– For hygienic purposes we recommend that you empty the container and clean the filter
after each use.
– The maximum suction effect can only be achieved with a clean HEPA filter and an
empty dust container.
– We recommend cleaning the HEPA filter each time when the dust container is emptied.
– When vacuuming very fine dust, the HEPA filter pores may become clogged, which
reduces air permeability and the suction performance. In this case, it is required to
clean the HEPA filter even when the tank is not full.
Clean the surface of the vacuum cleaner, extension attachment, charging base and adaptor
with a soft wet cloth. Do not use any rough and aggressive detergents!
Accessories
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Floor nozzle with rotary brush
Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush. To make cleaning
easier, the brush can be removed (Fig. 5).
Mop attachment
Let any excessive water (solution) drain away from the mop attachment,
e.g. to a washbasin. Rinse the attachment F under running water. The mop pads
(F1, F2, F3) can be washed in a washing machine at 60 °C and dried in a tumble dryer.
Notes
Notes
29 / 54
EN
with one fill.
2