AL-KO SnowLine 760.4 TE LED Betriebsanleitung Seite 43

Help in case of malfunctions
1. Switch off the appliance and remove the
spark plug connector.
2. Remove the cotter pin (48/1) (48/a).
3. Pull out the damaged shear pins (48/2) (48/
b).
4. Inspect the shaft for damage.
5. Insert a new shear pin and secure with cotter
pin.
9.5 Fine adjustment of the transport auger
height [760.4 TE LED only] (49)
By adjusting the screw (49/1), a fine adjustment
can be carried out to raise or lower the transport
auger and the plough.
The operating mode lever (02/15) adjusts the
screw:
■
The figure (49) shows the position of the
screw for "Packed Snow". Slightly raise the
snow blower in this position.
■
In the "Transport" position, the axle is fixed.
■
For operation, the operating mode lever must
be set to "Normal".
9.6 Adjusting the chain tension [760.4 TE
LED only] (50)
The tension of the chains can be adjusted by
tightening the nuts (50/1) on the hook (50/2).
Each caterpillar can be adjusted.
10 HELP IN CASE OF MALFUNCTIONS
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
■
Switch off the engine and check that the en-
gine is at a standstill!
■
Remove the spark plug connector!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Malfunction
Engine does not
start.
474911_e
Remedy
Fill with petrol.
Move the throttle lever to
the "Start" position.
Switch on the choke and
press the primer button.
Service the spark plug.
Malfunction
Engine loses
power.
Travel drive
does not func-
tion with clutch
lever pressed.
Travel drive can-
not be stopped
(does not disen-
gage).
Transport auger
does not rotate
with clutch lever
pressed.
Transport auger
cannot be
stopped (does
not disengage).
Abnormal appli-
ance vibrations.
Appliance pulls
to one side.
Replacement parts
See: www.al-ko.com
Remedy
Clean the discharge chan-
nel/housing.
Clear snow and ice from
the transport auger and
discharge wheel.
Reduce the working speed.
Adjust the Bowden cable.
Take the appliance to a
Customer Service Centre.
■
Switch off the engine.
■
Do not try to repair the
appliance yourself!
■
Take the appliance to
a Customer Service
Centre.
Shear ping broken; replace
the shear pin.
Adjust the Bowden cable.
Take the appliance to a
Customer Service Centre.
■
Switch off the engine.
■
Do not try to repair the
appliance yourself!
■
Take the appliance to
a Customer Service
Centre.
Inspect transport auger
and discharge wheel.
Check tyre pressure and
correct, if necessary.
Check the skids and adjust
or replace, as necessary.
43