Hettich UNIVERSAL 320 Gebrauchsanweisung Seite 69

5.4 Switching the centrifuge on and off.
Switching the centrifuge on
Switching off the centrifuge
6 Operation
6.1 Opening and closing the lid
Opening the lid
Closing the lid
AB1401en
2. Check whether the mains voltage matches the specification on the
rating plate.
3. Connect the device to a standard mains socket using the mains
cable.
Personnel:
■
Trained user
Set the mains switch to
�� The buttons flash, depending on the centrifuge type.
The following indicators appear one after the other, depending on
the centrifuge type:
■
the centrifuge model and program version
■
When the lid is closed:
■
When the lid is open: The last centrifugation data used.
The rotor is stationary.
Set the mains switch to
Personnel:
■
Trained user
The centrifuge is switched on
The rotor is stationary.
[STOP/OPEN] button.
Press the
�� The lid unlocks by means of a motor.
The light on the left side of the
CAUTION
Crushing hazard when closing the lid.
Danger of fingers getting crushed when the closing motor
pulls the lid against the seal.
−
No parts of the operator's body should be in the hazard
zone of the lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
Rev.: 13 / 11.2023
[I] .
'OPEN OEFFNEN' indicator
[0] .
[STOP/OPEN] button goes out.
Operation
21 / 44