Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Picture 29
FITTING INSTRUCTIONS
To fit the crash protectors, both side fairings must first be removed from the motorcycle.
To do this, start by removing the plastic panel under the nose of the bike by removing the four
plastic fasteners with a Phillips screwdriver, as arrowed in pictures 1 & 2.
Remove this plastic panel from the motorcycle.
To remove the right side fairing, start by removing the push/pull rivet that secures the inside
black plastic in place in the area around the top of the radiator, as arrowed in picture 3. Simply
pull the rivet head to remove the rivet.
Remove the three bolts that secure the lower edge of the fairing to the bellypan, as shown in
picture 4.
Remove the two bolts that secure the top edge of the fairing to the nose, as shown in picture 5.
Remove the bolt that secures the fairing to the black plastic that covers the intake tunnel, as
shown in picture 6.
The fairing can now be removed. Gently unclip the lower corner of the side fairing from the
front of the bellypan and work your way along the edge, unclipping the fairing tabs from the
slots in the bellypan as you go along, as shown in picture 7.
At the top rear corner of the fairing, where it meets the frame, there is a plastic prong that fits
into a rubber mount that needs to be lifted upward to release, as shown in picture 8.
With this out, the fairing should be free to slide forward and out to remove from the
motorcycle. Picture 9 shows the final plastic mounting points on top of the intake tunnels that
the fairing needs to be removed from and the inner radiator cowling plastic will come away
with the fairing.
Repeat the above procedure to remove the fairing on the left side.
On the left side of the bike, remove the main engine bolt, as shown in picture 10.
Take the left side mounting block (item 11 – M0515) and apply two and a half lengths of the
foam stirps (item 17) to the reverse side, as shown in picture 11. Apply one of the rubber
strips (item 12 - RG0032) and adhere this along the top of the block, aligning the profile with
the edge, as arrowed in picture 11. Please note that the small hole arrowed on the mounting
blocks in picture 30 is no longer used.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com
CP0426
Picture 30
Email:
info@rg-racing.com
Werbung
