R&G CP0245BL Montageanleitung

FITTING INSTRUCTIONS FOR CP0245BL/WH CRASH PROTECTORS
TOWARDS REAR
OF BIKE
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
You will need the following tools to complete this job.
Set of metric allen keys.
Socket set to include 17mm and 19mm A/F socket and wrench.
Torque wrench to be used at 40NM.
Phillips and flat screwdrivers.
Left-hand side (as you sit on bike)

Remove lower fairing (solid coloured piece only).

Loosen the engine bolt in position arrowed above left, paint or tippex bolt head and loosen so
when fairing is offered into position the inside of fairing is marked by paint (you may have to
remove a small amount of fairing padding from around the area the fairing is to be drilled).
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
HONDA CBR600RR 2009-
R&G Racing
www.rg-racing.com
TOWARDS FRONT
OF BIKE
Email: info@rg-racing.com