Fronius PushPull Installationsanleitung Seite 22

Danger of injury due to protruding wire electrode, rotating gears and drive
parts.
This can result in serious personal injuries.
▶
▶
22
CAUTION!
Hold the welding torch away from face and body.
Do not touch rotating gears or wirefeeder drive components.
Press the torch trigger or the "Fee-
8
der inching" button. The wirefeeder
motors are aligned while under
load. During the alignment operati-
on, the right-hand display will
read "run".
If it is not necessary to perform
the alignment on a push-pull unit
while this unit is under load (St2),
the previously set values -
e.g. "PPU" and "5" - will appear on
the display as soon as you press
the torch trigger or the "Feeder in-
ching" button.
The alignment operation on the
9
pushpull unit is finished when the
previously set values - e.g. "PPU"
and "5" - reappear on the display.
Press the Store button twice to
10
exit from the Set-up menu.