Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
54
Binzel robot push-pull "Master Feeder BG II" *) **) ***)
55
Fronius "VR 1530 PD" unreeling device (d = 1.0mm or 0.040 in; material:
steel) ***)
56
Fronius "VR 1530 PD" unreeling device (d = 1.2mm or 0.045 in; material:
steel) ***)
57
Fronius "VR 1530 PD" unreeling device (d = 1.6mm or 1/16 in; material:
steel) ***)
59
Fronius manual push-pull "PT Drive" (d=1.0 mm or 0.040 in; material:
steel, CrNi, CuSi3) ***)
60
Fronius manual push-pull "PT Drive" (d=1.2mm or 0.045 in; material:
steel, CrNi) ***)
61
Fronius manual push-pull "PT Drive" (d=0.8mm or 0.030 in; material:
steel, CrNi) ***)
62
Binzel robot push-pull 32V with IWG *) **) ***)
*)
It is not necessary to perform the alignment while the unit is under load
(St2)
**)
Motor and gear tolerances may cause functional deviations. In this case it
may be necessary for alignment to be carried out at Fronius'.
***)
Software must be specially enabled
CAUTION!
Danger of injury due to rotating gears and drive parts.
This can result in serious personal injuries.
▶
Do not touch rotating gears or wirefeeder drive components.
Engage the drive units of both wirefeeder motors (e.g. welding torch and
7
wirefeeder) once again - the wirefeeder motors must be under load (push-
pull alignment - engaged)
Press the torch trigger or the "Fee-
3
der inching" button
Disengage the drive units of both
4
wirefeeder motors (e.g. welding
torch and wirefeeder) - the wire-
feeder motors must not be under
load (pushpull alignment - open
circuit)
Press the torch trigger or the "Fee-
5
der inching" button. The wirefeeder
motors are aligned while not under
load. During the alignment operati-
on, the right-hand display will
read "run".
As soon as the alignment operation
6
- in the unloaded state - is comple-
te, the display will read "St2".
21
Werbung
Inhaltsverzeichnis
