Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E N
S E R V I C E
Service
GENERAL
All maintenance activities must happen at an disconnected machine and hoses
without pressure.Checking the electric components can happen exclusively by
an expert. Exclusively accessories and replacement components which have
been approved by the manufacturer can be used. Directly after the activities all
securities- and protection parts must be assembled, before the machine is put
in functioning. "a golden rule" that contributes to a perfectly working machine
with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly at
regular times with a thorough maintenance.
Therefore the experience and the "know-how" of DiBO a technical good
working machine is insured and large maintenance turns can be carried out
by experienced DiBO technicians by means of appointment or maintenance
contract, we can suppose in advance that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1
General
The user can carry out only those actions for which in this book authorisation
are given. Each other act has been prohibited!
2
Periodic maintenance
DESCRIPTION
Control of the electric cables, high and low pressure
hoses and couplings, filters and control of the oil
Replacement fuel filter
Cleaning fuel tank
Complete maintenance of the hotbox
Refreshing pump oil
All following refreshments of pump oil and services
3
Cleaning water filters
Clean the water filters regular and remove possible dirt.
4
Replace/cleaning fuel filter/fuel tank
Dismantle the fuel filter, and replace. Empty the fuel tank. Remove the drain
plug and catch possible dirt in a barge. Rinse the tank with a little bit off clean
fuel and unbolt the drain plug. Take care for tightened fuel hoses (clamps on the
conduits!) to the fuel filter at a replacement!
5
Maintenance at expense of DiBO technician
For further maintenance (burner, motors and parts who has to do with safety)
we advise to contact your DiBO distributor concerning a maintenance contract.
The maintenance applies to normal company circumstances. At heavy
circumstances you can communicate this so that can be taken into account.
Supplement documents:
• Control manual
• CE- certificate
Remarks: We advise the owner/user at strongest to make an appointment with
DiBO against reaching the given up company hours, to be able to guarantee a
good and regular maintenance concerning a maintenance turn.
DiBO 24
level
PERIOD
After each use
First 50 hours, each
following 200 hours/
half yearly
First 50 hours, each
following 200 hours/
half yearly
Each 200 hours
First 50 hours
Each following 200
hours/half yearly
Werbung
