Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12 WAT E R S U P P LY O P T I O N VA LV E
The water supply option valve can be used only in 'low pressure' mode. Here
you can choose to use drinking water supply or supply from an external water
tank. Place the valve in the desired position (see picture left).
• Valve downwards: drinking water supply.
• Valve to the left: external water tank supply.
You have to connect the water hose also to the
machine through external tank connection or
through the normal water supply connection.
• When using the water supply connection (drinking water supply, the water
will flow first through a float tank. The water tank prevents that there may
appear pressure impulses in the water system.Pressure impulses appears by
switching on and off the spray jet. The tank has also an overflow for draining
the excess of water.
• When using the water tank connection, you have to be aware that the external
tank is placed higher than the water force pump to ensure sufficient water
supply to the machine. Also make sure that the hose length to and from the
water tank is not to long. If there is no sufficient flow, ensure for appropriate
measures and check all other possible supply restraints (eg. : tube diameter,
suction in the tank, ...) that could have a negative influence.
13 S P R AY E Q U I P M E N T
Connect the spray equipment in the correct way. This means (see below):
• (1) When you use the machine in "High Pressure" mode: use the grey high
pressure hose !
• (2) When you use the machine in "Low pressure" mode: use the red spray
hose (with heat protection)
1
14 S E L E C TO R VA LV E
The selector valve is situated right on the operating compartment against the
frame.
• Vertically: high pressure cleaning activated (use the appropriate spray
equipment).
• Horizontally: 'high temperature function' activated (use the appropriate
spray equipment). The 'high temperature function' is a function that makes it
possible to counter pollution via hot water .
DiBO 19
C O M P O N E N T S
2
E N
Werbung
