Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung Seite 22

Device configuration, application setup
"Application -
Batch mode"
menu items
"Required inputs" Specify which data fields must be input before a batch can be started. A batch cannot be started until
submenu the selected required fields have been input.
Fig. 2:
Identifier
Batch name
Batch number
Preset counter
22
Configurable parameters
(factory settings are highlighted in bold)
Setup - Application - Batch mode, "Required inputs" submenu
Specify if the batch designation must be input so that a batch can
be started. Picklist: no, yes
Specify if the batch name must be input so that a batch can be
started. Picklist: no, yes
Specify if the batch number must be input so that a batch can be
started. Picklist: no, yes
Specify if the preset counter must be input so that a batch can be
started. If "no", the last preset counter is reused.
Note: Only relevant if batch is ended per preset counter.
Picklist: no, yes
Graphic Data Manager
Direct
access
code
16070/000
16071/000
16072/000
16073/000