Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung Seite 27

Graphic Data Manager
"Application -
Signal groups"
menu items
Batch assignment Configure what batch this group belongs to.
Note:
- Channels can be assigned to multiple batches/groups.
- Only relevant for batch printout.
Picklist: Do not assign any batch, Assign all batches, Batch x
Save group The group will always be saved or only when the allocated batch is active.
(only if "Batch Picklist: Only when batch is active, always
assignment" - "Batch
x")
2.5 Setup - Application - Signal groups
Settings for signal groups for batch mode.
NOTICE
Only settings relevant for batch mode are described here. For all the other signal analysis
functions, see the Operating Instructions.
Fig. 7: Setup - Application - Signal Groups - Group x
Configurable parameters
(factory settings are highlighted in bold)
NOTICE
The modified settings do not take effect until you return to the normal operating mode
by pressing "Back" repeatedly (confirm setup is accepted with "Yes"). Until this time,
the device still works with the previous data.
Device configuration, application setup
38225/000 to
38225/009
38230/000 to
38230/009
Direct
access
code
27