Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung Seite 23

Graphic Data Manager
"Application -
Batch mode"
menu items
"Printout" submenu Settings for batch printout (only relevant if device has printer connected).
Note: Only channels which are assigned to an active batch are printed out, i.e. if "Batch x" or "Assign
all batches" is configured under "Application -> Signal groups -> Group x -> Batch assignment" - in
Setup. All other channels are disabled.
Fig. 3:
Autom. printout
Printout: Field 1
(only available in expert
mode!)
Printout: Field 2
(only available in expert
mode!)
Printout: Field 3
(only available in expert
mode!)
Number of copies
Configurable parameters
(factory settings are highlighted in bold)
Setup - Application - Batch mode, "Printout" submenu
At the end of a batch, a batch report can be printed out at a
connected printer.
Picklist: no, yes
Note: You can only print if a printer is connected to the device!
Each RS232 printer can be used.
Please refer to the Operating Instructions for information on the
USB printers supported.
Pin assignment RS232 printer (SUB-D 9-pin):
Device : printer
5 ---------- 5
2 ---------> 3
3 <--------- 8
The batch report has 3 fields which the user can fill in individually
after printing out the report. Here, configure the name for this field.
Text entry: max. 22-digit. Factory setting: Operator
The batch report has 3 fields which the user can fill in individually
after printing out the report. Here, configure the name for this field.
Text entry: max. 22-digit. Factory setting: QA responsible
The batch report has 3 fields which the user can fill in individually
after printing out the report. Here, configure the name for this field.
Text entry: max. 22-digit. Factory setting: Date/Time
Configure how many copies should be printed out.
Picklist: 1, 2, 3
Device configuration, application setup
16005/000
16015/000
16020/000
16025/000
16027/000
Direct
access
code
23