Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung Seite 29

Graphic Data Manager
• Preset counter
• Remote access, i.e. using PC operating software or OPC server
• Profibus or Modbus
• Barcode reader
An analysis is saved at the end of a batch. The analysis is displayed under "Main menu -
Extras - Signal analysis".
Note:
• The batch status (started or ended) is retained even after a power failure.
• There must be at least 200 ms between 2 of the same batches (stop/start).
• The minimum duration of a batch is 1 s. Batches that are shorter than this are not
recorded.
• A new batch cannot be started until the old one is ended.
• The start and end of batches are recorded in the event log.
2.6.3 Batch control using the PC software
Batches can be controlled using the PC software provided under "Extras-> Special unit
functions -> (Select device) -> Remote control":
Fig. 9: Batch control using PC software
Note:
• Not possible if batches are started and stopped via digital input!
• The batch information can only be modified if the batch has stopped. The information
entered is only transferred to the device when the batch is started.
• If the device' s user administration is active, a password must be entered to start/end the
batch. The user must have the appropriate rights.
Displaying and printing out the batches in the PC software
NOTICE
Before printing out the batch, use the PC software provided to first specify the channels
to be displayed/printed out (see Section 8 of the Operating Instructions on the CD-ROM
of the PC software).
Device configuration, application setup
29