Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung Seite 20

General description of the function
20
1 General description of the function
NOTICE
This manual constitutes an additional description for a special software option.
These additional instructions are not intended as a substitute for the Operating Instructions
provided in the scope of delivery!
For detailed information, refer to the Operating Instructions and other documentation.
Available for all device versions via:
• Internet: www.endress.com/deviceviewer
• Smart phone/Tablet: Endress+Hauser Operations App
Definition of the batch function:
A batch in production refers to the total of all units of a product, produced, manufactured or
packed under the same conditions. A total of this type is generally assigned a unique lot
number (batch number) and this number is also often marked on the products in this lot.
The batches are assigned to a fixed signal analysis in the device (batch 1 -> analysis 1, batch
2 -> analysis 2 etc.). Note: if 4 batches are running in parallel, the operator cannot carry out
any further analyses (e.g. daily analysis). Only the totalizer is always determined.
A batch can be started or stopped manually at the device, using an external keyboard,
barcode reader, control input (digital input) or via remote operation (PC software or
fieldbus).
At the end of the batch, a batch report ("Signal analysis") is created with min/max/average
values and quantities. This can also be printed automatically. Furthermore, alarm statistics
can be generated relating to the batch report, with frequency and duration of set point
violations.
2 Device configuration, application setup
2.1 General programming guidelines
1. First install and configure the device as described in Section 1 to Section 6.4 of the
Operating Instructions. Observe all the safety instructions!
2. Make the additional settings needed for batch mode (see the next section).
3. Configure the display, i.e. group the values for displaying and select the display mode.
See from Section 6.5 of the Operating Instructions.
Graphic Data Manager