Setup - Application - Batch Mode - Endress+Hauser Graphic Data Manager RSG40 Memograph M Zusatzanleitung

Graphic Data Manager
"Application -
Batch mode"
menu items
The device processes The device can record up to 4 batches simultaneously. Configure how many batches the device should
process simultaneously. Picklist: Switched off, 1 batch per device, x batches simult. per device
Batch number Configure how the batch number is generated:
"Manual": You can enter any text as the batch number.
"Increase automatically": the batch number is automatically increased by 1 after the batch is finished.
Autom. batch readout Activate this function to make the PC software automatically read out the data and print it out as soon
as the batch is finished.
Note: Only available if the device is connected via Ethernet and the readout automation system is
started in the PC software.
Picklist: no, yes
IP address Enter the IP address of the reader PC here. Where necessary, contact your network administrator to
find out the IP address. Factory setting: 000.000.000.000
Port A connection to the reader PC is established through this communication port.
Note: If your network is protected by a firewall, this port may have to be enabled. In such instances,
contact your network administrator.
Factory setting: 0
2.2

Setup - Application - Batch mode

Required settings for batch mode.
NOTICE
Depending on the selected function, the device' s user interface adapts itself, so that each
time only parameters that are required for safe unit functioning have to be checked/set.
Fig. 1: Setup - Application - Batch mode
Configurable parameters
(factory settings are highlighted in bold)
Device configuration, application setup
16000/000
16030/000
16035/000
16040/000
16055/000
Direct
access
code
21