Coltene MicroMega Dual Move Bedienungsanleitung Seite 4

7. Installation of the contra-angle
Make sure the motor is stopped when installing the contra-angle.
Fig. 7.A
Connect the contra-angle to the handpiece properly. Use the original contra-angle only.
Fig. 7.B The contra angle can be 340° rotated without take off, to make it easy to watch the screen during treatment.
Put the protective silicon cover onto the contra-angle. When removing after use, pull it straight out slowly.
• Check the proper connection by pulling the contra-angle gently, to avoid unexpected motor reverse
during use.
8. Installation of the fi le
To install the fi le: insert the fi le and turn it, make sure it is correctly inserted.
Fig. 8.A
To remove the fi le: release the fi le while pressing the button.
• Make sure the motor is stopped before installing the fi le.
• Inspect the fi le head before inserting it. Do not use the fi le if its head is damaged.
• Pull the fi le gently to make sure it is securely connected.
• Insert or remove carefully the fi le to avoid fi nger injuries.
• File removal without pressing the button may damage the spindle.
9. Dual Move control
9. 1. User interface (Fig. 9.A, 9.B, 9.C)
9.A.1 Contra-angle
9.A.2 Main switch (power on, motor start / stop)
9.A.3 Key for selection.
9.B Standby screen
9.B.1 Battery level
9.B.2 Memory number
9.B.3 Running speed
9.B.4 Rotation direction
9. 2. Steps to operate
1. Power on / Power off with
To power
Automatic
To power off: press simultaneously 9.A.2 (
2. Select memory program with < / > buttons (Fig. 9.D)
7 different customizable programs. M0: reciprocating mode. M1...M6: continuous rotation
* M0 Reciprocation mode is only available when specifi ed on the box
• Never use reciprocating fi les in continuous rotation.
• Never use continuous rotary instruments in reciprocating mode.
4
(9.A.2 button)
on: push the 9.A.2
switch off if Dual Move
9.A.4 < / - key to select a memory or other parameters
9.A.5 > / + key to select a memory or other parameters
9.A.6 User screen
9.B.5 Reverse Torque value
9.C Display torque interface
9.C.1 Torque scale (N.cm)
9.C.2 Cursor of the reverse torque value
9.C.3 Real time torque display
button ( ), the standby
is not used for a
) and 9.A.4 ( ) buttons.
screen is displayed.
while (time-out to be set).