Stiga AM 98 Li 48 V1 Betriebsanleitung Seite 260

Cutting speed push-button
When started, the machine
automatically runs in "STANDARD"
mode. The button (fig. 9.T)
enables the three cutting device
speeds in the following sequence:
"STANDARD" > "BOOST"
> "STANDARD" > "ECO" >
"STANDARD".
"ECO" cutting speed icon
The icon (fig. 9.U) is lit when the
machine is in "ECO" cutting mode
and remains off when it switches
back to "STANDARD" mode. The
"eco" mode allows for significant
saving of battery power.
NOTE
We do not recommend the use of
the "ECO" function during heavy
grass cutting conditions (cutting of
thick, high, wet grass).
"BOOST" cutting speed icon
The icon (fig. 9.V) is lit when the
machine is in "BOOST" cutting
mode and remains off when it
switches back to "STANDARD"
mode.
6.8.3 Pushbutton panel (type "III") fig. 9
Machine START button
With the key fully inserted this
button (fig. 9.A) turns the machine
ON and enables all functions.
NOTE
If all safety conditions are met, the
white part of the circular element
of the display lights up (fig.9.B,
9.Y, 9.Z) and the battery status
is displayed (9.B and 9.Y ), the
cutting height (9.W) and the active
functions. The machine is ready to
be used (see chap. 7.4).
HEADLIGHT switch on button
By pressing the push-button
fig. 9.C the headlights are switched
on/off
When the headlights are ON, icon
fig. 9.N is illuminated
Cutting means engage and
disengage pushbutton
Press the button fig. 9.E to engage/
disengage the cutting means.
• When the cutting means
• When the cutting means are
NOTE
If the cutting means are engaged
without taking the necessary safety
precautions, the machine cannot
start (see par. 7.2.2)
Blade speed modes -
"STANDARD" mode
if no blade mode is selected
the blade speed is set to an
intermediate value
Cutting speed - "ECO" mode
button
This button (fig. 9.X) is used for light
cut and maximize the battery. When
this function is selected, the "leaf"
icon is illuminated (fig. 9.U).
It is not recommended to use this
function in heavy grass cutting
conditions (cutting of dense, high,
humid grass)
Cutting speed - "AUTOMATIC
CUT" mode button
By pressing the "AUTOMATIC CUT"
botton (fig. 9.J1), the machine
decides autonomously which is the
best blade mode according to the
load: no influence on traction speed.
When this function is selected,
the "AUTOMATIC CUT" icon is
illuminated (fig. 9.J2)
Cutting speed - "BOOST" mode
button
By pressing the "BOOST" mode
button (fig.9.0), the rotation speed
of the cutting means is increased to
cut grass in more difficult conditions
(dense, tall, wet grass). When this
function is selected, the "rotary
blade" icon is illuminated (fig. 9.V).
The machine autonomy is reduced.
EN - 14
are engaged, they become
operational after a few seconds.
disengaged, a brake is applied
simultaneously to stop them
rotating after a few seconds.
ATTENTION