Stiga AM 98 Li 48 V1 Betriebsanleitung Seite 254

CRUSHING HAZARD
Make sure that children stay
clear of the machine all the
time when motor is running.
CUTTING HAZARD
Cutting means in motion. Do
not put hands or feet near or
under the opening of the cut-
ting means housing.
SAFETY INSTRUCTIONS
Any damaged or illegible decals must be
replaced. Order replacement decals from an
authorised service centre.
4.3 IDENTIFICATION LABEL
The identification label holds the following data
(fig. 2):
1. Sound power level.
2. Conformity marking.
3. Year of manufacture.
4. Type of machine.
5. Serial number.
6. Name and address of Manufacturer.
7. Article code.
8. Max. motor operation speed.
9. Weight in kg.
10. Electrical protection rating.
11. Rated voltage.
12. Battery capacity.
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
SAFETY INSTRUCTIONS
Quote the information on the product
identification label whenever you contact an
authorised service workshop.
NOTE
The Declaration of Conformity is provided on the
last pages of the manual.
4.4 MAIN COMPONENTS
The machine is composed of a series of main
components that have the following functions
(fig.2):
A. Cutting-means assembly: this is the
assembly comprising the casing that houses
the rotating cutting means, and the cutting
means.
B. Cutting means: these are what cut the
grass; the fins at the ends help convey the
cut grass towards the discharge chute.
C. Side discharge chute: a safety device
to prevent objects drawn up by the cutting
means from being hurled by the machine
(only for side discharge models ).
D. Driver seat: this is where the machine
operator sits. It has a sensor connected to
safety devices for detecting the presence of
the operator.
E. Blade motor: supply the drive power to the
cutting means.
F. Transmission motor: provides drive power
to the rear wheels.
G. Battery: supplies power to the motors and all
the electrical components of the machine.
5. ASSEMBLY
CAUTION
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions
to avoid serious risks or hazards. Do not use the
machine until you have verified that the machine
has been delivered fully assembled, including
any removable parts indicated in the table
below and described in the following sections
"ASSEMBLY ...".
5.1 COMPONENTS AND PARTS
The equipment and parts that can be removed if
necessary include:
Description
1 Envelope containing:
- instruction manuals and documents
- 2 starter keys
2 Battery charger
3 Seat (only for models type "I", "II")
4 Side discharge chute (only for models
type "I", "II")
5 Cutting-means assembly side
reinforcement
5.2 FITTING THE SEAT (ONLY FOR
MODELS TYPE "I", "II")
You will find the armrests and the components for
their installation in a separate box in the machine
packaging.
Fit the seat (fig. 3.A) onto the plate (fig. 3.B) using
the screws (fig. 3.C) and the spacers (fig. 3.D).
For disassembly follow the instruction
in the reversed order
EN - 8
(only for model type "II")
.