Stiga AM 98 Li 48 V1 Betriebsanleitung Seite 257

1. Neutral: the machine remains
stationary with both transmission
brakes enabled.
2. Straight forward gear: by
gradually moving the manipulator
forward, the machine moves
forward in a straight line, at an
increasing speed.
3. Steering in forward gear: by
gradually moving the manipulator
forward and to the right or left,
the machine will move forward
turning to the right or left, at an
increasing speed.
4. Rotation to the right: by
gradually moving the manipulator
all the way to the right, the
machine rotates clockwise on its
own axis at an increasing speed.
5. Rotation to the left:
by gradually moving the
manipulator all the way to the
left, the machine rotates counter
clockwise on its own axis at an
increasing speed.
6. Straight reverse gear: by
gradually moving the manipulator
backwards, the machine
reverses in a straight line, at an
increasing speed.
7. Steering in reverse gear: by
gradually moving the manipulator
backwards and to the right or left,
the machine reverse turning to
the right or left, at an increasing
speed.
NOTE
The drive power is disabled when the operator
leaves the seat.
6.5 CUTTING HEIGHT ADJUSTMENT
HANDLE
6.5.1 Adjustment lever (only for models of
type "I" and "II")
Use this handle to raise and lower the cutting-
means assembly to one of the 8 different cutting
heights (fig. 8.E).
The eight positions are shown
as «1» to «8» on the plate, and
correspond to the same number of
cutting heights between 3 and 8 cm.
To switch from one position to
another, press the release lever
(fig. 8.E.1) and move the handle
(fig. 8.E.2) back into one of the stop
notches.
6.5.2 Adjustment buttons (only for models
of type"III")
These buttons are used to raise (fig. 9.K1) and
lower (fig. 9.K2) the cutting means assembly,
which may be positioned at 7 different cutting
heights.
The seven positions are graphically
indicated on the display (fig. 9.W)
and correspond to the same number
of cutting heights between 2.5 and
13.5 cm
To move from one position to
another, press the adjustment
buttons (fig. 9.K1, fig. 9.K2) until the
desired position is reached.
Alternatively, by holding down one
of the two adjustment buttons, it is
possible to change the height of the
cutting assembly continuously up to
the desired position.
NOTE
If the key is fully inserted (fig.8.A), pressing the
"STANDARD/PERFORMANCE"gear mode
button (fig.9.R) together with the lifting (fig.9.K1)
or lowering (fig.9.K2) buttons, it is possible to
raise or lower the cutting means assembly even
when the driver is not seated on board.
6.6 AUXILIARY PORT FOR USB
ACCESSORIES
This port (fig. 8.F) can be used to recharge USB
devices. It is only used for recharging.
The port has no communication function with the
connected USB device.
The socket is only live when the key (fig. 8.A) is
inserted all the way.
NOTICE
Do not charge the accessory connected to the
USB port in rainy, humid or high temperature
conditions with direct exposure to sunlight. If
EN - 11