Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DT-Mobil Easy:
Pick-up 210l, 440l and COMBI 440/50
i
Important:
Form-fit before force!
Most importantly, try to load the filling
station so it rests against one or more
sides (e.g. by slinging to the side of the
vehicle).
i
Important:
Excessive lashing forces may deform the
tank and thus damage it.
Recommendation:
Use a non-slip mat.
Important:
Risk of material damage to the filling sta-
tion with lid.
Airflow while driving can open the lid and
possibly tear it off. Therefore, always
transport the filling station with the hinges
in the direction of travel.
5.1.4
Filling the tank
1. Unscrew cap of filling opening C.
2. Fill the container through the filling opening
using a delivery nozzle with an automatic
shut-off.
3. After filling, seal filling opening C tightly again
using the cap.
4. Contamination of the container caused by the
filling process must be removed immediately
with a dry cloth.
5.1.5
Filling
1. For the version with hinged lid, open the
hinged lid closure
2. Version with terminal clamps:
Connect the terminal clamps D to a suitable
voltage source (see tank or pump type plates).
Observe the colour coding:
•
red = positive terminal (+)
•
black = negative terminal (-)
.
I
Version with battery:
The battery is partly charged at the time of
dispatch. Charge the battery before using for
the first time. Set On/Off switch to Off.
3. Switch on pump E at the switch.
4. To fill, remove delivery nozzle F from the
holder and fully insert the delivery spout into
the container/tank to be filled.
5. Operate automatic delivery nozzle F (if nec-
essary, lock with locking device) and carry out
the filling operation.
Tank ventilation and pressure relief are performed
automatically by the integrated valve C. For larger
delivery quantities, filling opening C should also
be opened.
i
Important:
Constantly monitor the filling process.
6. Close the automatic delivery nozzle F and
allow the fuel to drip off.
7. Switch off pump E.
8. Completely disconnect the pump from the
power source and roll up the cable.
9. Insert the hose and nozzle into the integrated
holder.
10. For the version with hinged cover, fold it down
and close hinged lid closure I.
5.2
DT-Mobil PRO PE
5.2.1
Storage
During transport and storage, do not expose the
DT-Mobil Easy to direct sunlight for an extended
period of time. Excessive heating can lead to a
reduction in the fuel quality.
Suitable storage conditions:
•
Ambient temperatures from -10 °C to +40 °C.
•
Level surface.
•
Cover for outdoor storage.
5.2.2
Loading the filling station
Risk of injury!
The lid must be closed.
GB
31
Werbung
