Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
Clamping the Workpieces
Only work on workpieces that can be secu-
rely clamped between the chuck jaws. The
workpiece must not yield too much. Other-
wise it is nor possible to apply adequate
tension.
The workpiece must not be too small or too
large either.
Removing Blockages
-
You should always select a suitable
feed rate which allows trouble-free chip
breaking.
-
If the bit is jammed in the workpiece,
turn off the power and unplug the po-
wer cord. Turn the bit on the drill chuck
anticlockwise with a little jerk to break
the chip and release the bit again.
-
If a fragment is produced during the
processing of the workpiece, turn off the
power and unplug the power cord. Use a
pair of pliers and remove the fragment to
prevent it flying off in an uncontrolled way.
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by
a professional. Only use ori-
ginal parts. Allow the device
to cool off before any mainte-
nance or cleaning is underta-
ken. There is a risk of burning!
Always check the device before using it
for obvious defects such as loose, worn or
30
damaged parts, correct the positioning of
screws or other parts. Exchange the dama-
ged parts.
Cleaning
Do not use any cleaning agents or
solvents. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Remove chips, dust and dirt with a va-
cuum cleaner if necessary.
• Lubricate moving parts regularly.
• Do not allow lubricants to come into
contact with switches, V-belts, pulleys
and drill lifting arms.
Checking the V-belt
1. Unscrew the locking bolts on the gear
cover (1).
2. Open the gear cover (1).
3. Check the V-belt (31) for tears, cuts or
other damage.
4. Close the gear cover (1). Fasten the
locking bolt on the gear cover (1).
Changing the V-belt
1. Unscrew the locking bolts on the gear
cover (1).
2. Open the gear cover (1).
3. Remove the circlip (28) from the drive
wheel (30).
4. Unscrew the grub screw (29) on the
drive wheel (30).
Werbung
