Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
Technical Data
Bench Pillar Drill ....... PTBM 550 A1
Rated input voltage U .......230 V~, 50 Hz
Idle power consumption P
Power input ............. 550 W (S6 15%)**
)
Idling speed (n
0
Spindle ......................450 - 2600 min
Motor ................................ 1490 min
Safety class .......................................... I
Protection category...........................IPX0
Weight (with accessories) ............ 23.5 kg
Drill chuck ..............B16 (1 mm to 13 mm)
Spindle stroke .............................. 60 mm
Laser
Laser class ........................................ 2
Laser wavelength .....................650 nm
Laser power P
........................< 1 mW
0
Sound pressure level
) ....................... 72.7 dB; K
(L
pA
Sound power level (L
measured .......... 85.7 dB(A); K
* Operating mode S1: Continuous operation
with constant load
** Operating mode S6 15%: Continuous ope-
ration with intermittent load (cycle time 10
min). In order not to heat the motor more
than permitted, the motor may only be
operated for 15% of the cycle time with the
stated nominal power and must then continue
running for 85% of the cycle time without a
load.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
The specifi ed noise emission value has
been measured according to a standar-
dised testing method and may be used for
comparison with another power tool.
The specifi ed noise emission value can
also be used for a provisional assessment
of the load.
22
...350 W (S1*)
0
= 3 dB
pA
)
WA
= 3 dB
WA
Warning:
The noise emissions may deviate
from the specifi ed values during
actual use of the power tool, de-
pending on how the power tool is
being used and, in particular, what
kind of material is being worked
on.
-1
-1
Safety measures for protection of
the operator are to be determined
that are based on an estimate of
the load under the real operating
conditions.
Notes on safety
Caution! When using power tools,
observe the following basic safety
measures for the prevention of
electric shocks and the risk of injury
and fi re.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.
Symbols and icons
Symbols on the device:
Warning!
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!
Wear ear protection
Wear eye protection
Do not wear long hair uncovered.
Use a hair net.
Werbung
