Parkside PGKGA 40-Li B2 Originalbetriebsanleitung Seite 68

GB MT
1. Switch off the device and remove the
batteries from the device.
2. Release the nut (34) and remove the
sprocket cover (33). Remove the saw
chain (1) and the blade bar (35).
3. Check the blade bar (
Remove burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passage (
sure fault-free, automatic oiling of the
saw chain during operation.
5. Turn the blade bar (35) once along its
horizontal axis.
6. Place the saw chain (1) into the blade
groove. Place the saw chain (1) into
the chain sprocket (36).
7. Place the blade (35) and saw chain
(1) on the coach screws (37). When
the nose on the right below the coach
screw (37) sits in the lower round re-
cess on the blade bar, the blade bar
is placed correctly. It is normal for the
saw chain (1) to sag.
8. Pre-tension the saw chain (1) by turning
the screw (38) to tension the chain in
a clockwise direction. Also see section
"Tensioning the saw chain".
9. Place the sprocket cover (33) into posi-
tion. Tighten the nut (34) of the socket
cover.
Replacing the spool
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (
using the hexagon socket wrench
( 22) as depicted.
Screw the spool cap (17) clockwise
to the mounting spindle (
4. Open the spool cap (17) by firmly
pressing the quick-release catch (56)
68
5. Place the new spool (57) into the spool
35) for wear.
6. Place the spool (57) inside the lid of
61) to en-
7. Screw the spool cap (17) anticlock-
8. Trim the thread line to approx. 15 cm.
1. Switch off the engine and remove the
2. Screw off the line cutter (15) from the
3. Clamp the line cutter (15) in a vice and
4. Screw the line cutter (15) back onto the
52)
As an alternative to a new thread spool,
52).
you can purchase a 2.4 mm-thick, 5 m-long
nylon thread in specialist shops and wind
this yourself onto the thread spool.
inwards on both sides of the spool cap
(17), and remove the spool cap cover.
cap cover (17) and insert the two ends
of the thread through the thread outlets
(58). Loosen the two thread ends from
the grooves (
60) on the spool.
the spool cap (17) and reassemble the
lid and base.
wise back onto the mounting spindle
( 52). Remove the hexagon so-
cket wrench (
Sharpen the line cutter
Never use the device without
a string cutter or defective
line cutter. There is a risk of
injury. If the thread trimming
blade is damaged, be sure to
contact our service centre.
Wear protective gloves in order to
avoid cutting yourself.
batteries.
protective cover extension (16).
sharpen the knife with a flat file. File ca-
refully, and always in one direction only.
protective cover extension (16).
Winding up the spool
22).