Parkside PGKGA 40-Li B2 Originalbetriebsanleitung Seite 56

GB MT
d) When the machine is not being used,
store it out of the reach of children.
Brush cutter - kickback
causes and how to avoid
them with a 3-tooth blade
In the event of a kickback,
the operator will feel a pow-
erful blow from the combina-
tion machine. This may lead
to losing control of the device
and serious injury. You can
avoid kickbacks through cau-
tion and proper technique.
While working with the 3- tooth blade the-
re is a risk of kickback if the blade edge
hits an obstacle (stone, wood).
• Hold the device with both hands.
• Make sure there are no obstacles on the
ground and do not use the 3-tooth blade
near fences, metal posts or similar.
Additional safety
instructions
• Hold the power tool only by the insu-
lated gripping surfaces as the cutting
blade may come into contact with con-
cealed power lines. Contact with a live
wire can also cause a charge in metal
parts of the appliance and result in an
electric shock.
• Carefully inspect the surface to be cut,
and remove all wires and other foreign
bodies.
56
Use only properly
sharpened tools. To cut
thick stems, switch the
device to position A.
• Check the appliance before each use
for obvious defects such as loose,
worn or damaged parts. Check the
appliance for significant damage or
defects if it is dropped.
• If the device has been dropped or
struck, you must check the device befo-
re starting it and ensure it is in a good
condition.
• Caution! Local regulations may restrict
use of the machine.
• Always maintain the device and cut-
ting tool in a good condition.
• Observe the following: Improper
maintenance, the use of non-compliant
spare parts or the unauthorised remo-
val or modification of safety equipment
can lead to damage to the device and
serious injuries to the person working
with the device.
• Secure the device well during transport
to prevent damage to the device and
injuries.
• Before use, check the device for loose
fastenings and damaged parts, such
as cracks in the cutting attachments.
• Do not use any accessories
that are not recommended by PARK-
SIDE. This can result in electric shock
or fire.
Observe the safety in-
formation and notes on
charging and proper use
as shown in the instruction
manual for your battery
and charger from the (Park-
side) X 20 V Team series. A
detailed description of the
charging process and further
information can be found in
the separate operating in-
structions.