Parkside PGKGA 40-Li B2 Originalbetriebsanleitung Seite 46

GB MT
String length ................................. 5 m
Speed, spool n .................... 7000 rpm
Max. speed, spool n
Vibration on handgrip
(a ) ..............3.690 m/s
h
Vibration on round handle
(a ) ............. 4.320 m/s
h
Sound pressure level
(L ) ....................... 82 dB; K
pA
Sound power level (L
measured ...... 93.6 dB, K
guaranteed ............................ 96 dB
Brush cutter
Cutting diameter,
3-tooth blade ................... ca. 25 cm
Speed, blade n .................... 7300 rpm
Max. speed, blade n
Vibration on handgrip
(a ) ..............3.690 m/s
h
Vibration on round handle
(a ) ............. 4.320 m/s
h
Sound pressure level
(L ) ....................... 82 dB; K
pA
Sound power level (L
measured ...... 93.6 dB, K
guaranteed ............................ 96 dB
For use with smart batteries
(Smart PAPS 204 A1/Smart PAPS 208 A1)
Operating frequency/
Frequency band .... 2400 - 2483.5 MHz
Max. transmission power .......≤ 20 dBm
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
46
........13300 rpm
max
2 ; K= 1.5 m/s
; K= 1.5 m/s
2
= 3 dB
pA
)
WA
= 2.24 dB
WA
...... 10000 rpm
max
; K= 1.5 m/s
2
2 ; K= 1.5 m/s
= 3 dB
pA
)
WA
= 2.24 dB
WA
Warning: The vibration emission value
may differ during actual use of the power
tool from the stated value depending on the
manner in which the power tool is used.
Try to keep the exposure to vibrations as
2
low as possible. Examples of measures to
reduce vibration exposure are the wearing
2
of gloves when using the tool and limiting
the working hours. For this purpose all
parts of the operating cycle have to be
considered (for example, times when the
electric tool is switched off and times when
it is switched on but running without any
load).
Charging time
The device is part of the (Parkside) X 20 V
TEAM series and can be operated with
2
batteries of the (Parkside) X 20 V TEAM
2 series.
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
We recommend that you operate this
appliance with the following batte-
ries only: PAP 20 A1, PAP 20 A2,
PAP 20 A3, PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1.
We recommend charging these batteries
with the following chargers: PLG 20 A1,
PLG 20 A2, PLG 20 A3, PLG 20 A4,
PLG 20 C1, PLG 20 C3, PDSLG 20 A1,
Smart PLGS 2012 A1.