Parkside PGKGA 40-Li B2 Originalbetriebsanleitung Seite 59

Mounting the protective
cover
The protective cover (14) must be mounted
to the front tubular shaft (2) with the retai-
ner for spool and 3-tooth blade.
1. Screw the protective cover (14) to the
front tubular shaft (2) using the two
small Phillips screws (49). Use the Phil-
lips screwdriver (24) for this.
2. Fasten the cover (50) to the protective
hood (14). Use the hexagon socket
wrench (22) and the three screws (51).
Removing/mounting
the protective cover
extension
If using the 3-tooth blade, the protective
cover extension must be removed.
If using the spool, the extension must be
mounted.
Removing the protective cover
extension:
1. Unlock the extension lock (16) on the
protective cover (14) with the slotted
screwdriver (24). The lock is located
on the inside of the extension of the
protective cover on the side of the line
cutter (15).
2. Remove the protective cover extension
(16).
Mounting the protective cover
extension:
1. Slide the extension (16) onto the
protective cover (14). Begin on the side
without the string cutter (15).
2. Slide the extension (16) up until it clicks
into place.
Clean the extension (16) and pro-
tective cover (14) after each use.
Initial Operation
When working with the de-
vice, wear suitable clothing,
work gloves, eye protection,
protective headgear, hearing
protection and cut-resistant
work boots. Prior to each use,
ensure that the machine is
working correctly. Do not lock
the On/Off switch in place.
Do not use the device if a
switch is damaged. Risk of in-
jury and damage to property.
Note noise protection and local
specifications. The use of the equip-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
Chain lubrication
The blade bar and saw chain must
never be operated without oil. If the
pole-mounted pruner is used with
too little oil, the cutting performance
and lifespan of the saw chain will
decrease as the saw chain will be-
come blunt more quickly. You can
identify when there is too little oil
if smoke develops or the blade bar
changes colour.
The oil flows to the blade bar as soon as
the motor starts working.
GB MT
59