Parkside PGKGA 40-Li B2 Originalbetriebsanleitung Seite 57

Assembly
Remove the battery from the
device before carrying out
any work on the device.
Only use original parts.
The device can be used with either
the hedge trimmer, pole-mounted
pruner or trimmer attachment, eit-
her with spool or 3-tooth blade.
Dismantling is carried out in reverse
order.
Remove/insert battery
1. To remove the battery (25) from the
device, press the release button on the
battery and pull the battery out.
2. To insert the battery (25), push the
battery along the guide rail into the
device. You will hear it click into place.
Only insert the rechargeable
batteries once the device is
completely assembled. Risk
of injury!
Mounting the tubular
B
shaft
Before mounting, remove the pro-
tective cap(s) from the front tubular
shaft (2).
1. Loosen the wing nut (3).
2. Pull the lock (8) outward and turn it left
or right as far as it goes.
3. Slide the front tubular shaft (2) onto the
tubular shaft on the device housing (4).
4. Pull the lock (8) outward and turn it
back to its original position.
5. Turn the front tubular shaft (2) with a
gentle rotating movement until the lock
(8) clicks into place in the bore on the
front tubular shaft (2).
6. Fix the tubular shaft in place with the
wing nut (3).
Tighten the butterfly screw
(3) until no more play is dis-
cernible on the front tubular
shaft (2)! The use of maxi-
mum manual force will da-
mage the tubular shaft.
Mounting the round
C
handle
The round handle must be
mounted with a spacing of
at least 25 cm to the device
handle!
The leg protection must al-
ways be mounted on the
operator side!
1. Loosen the star grip screw (3) and fold
the leg protection (7) away.
2. Place the round handle (5) onto the
tubular shaft of the device housing
(4). Choose a position within
the levelled adjustment range
marked on the bottom of the tu-
bular shaft. The area is marked
with a label.
3. Close the leg protection (7) and tighten
it using the star grip screw (3).
Mounting the saw chain
Pay attention to the correct rotation
direction of the saw chain. This is
indicated on the chain wheel cover
(33) and above the bar bolt (37).
GB MT
57