Werbung
Verfügbare Sprachen
Verfügbare Sprachen
H07 RN-F) with a cross-section of no
less than 5 x 2.5 mm². Take care not to
pull the cable over sharp edges.
– Take the environmental influences into
consideration. Do not expose the machi-
ne to rain. Avoid operating it in a moist or
wet environment and close to combu-
stible liquids or gases.
– When operating the machine out of do-
ors, we recommend that you use a resi-
dual-current circuit breaker.
– Switch the main switch off before chan-
ging the milling tool and before troubles-
hooting.
– Only use the milling tools comprised in
the delivery. Be sure never to use a blunt
tool.
– When the machine is shut down for a
longer period of time, secure the swit-
ched-off main switch against accidental
activation by locking it with a padlock.
Information on the use of personal sa-
fety equipment
– Always wear closely fitting work clothes
and remove rings, bracelets and wrist-
watches before starting to work.
– Always wear suitable gloves when ope-
rating the tenon cutting machine and
changing tools.
– To protect your eyes from injury, wear
eye protection (goggles) or face protec-
tion when operating the machine.
– The noise level at the ear is greater than
85 dB (A). For this reason, wear ear pro-
tection when operating the machine.
Information on operation
– Always lead the electrical connecting ca-
ble away from the machine and lay it in
such a way that there is no tripping ha-
zard at the operator station.
– Make sure that the operator station is fre-
ely accessible, sufficiently lighted, and
slip-proof.
– Ensure that there are no other individuals
in the working space, in particular no
children.
– Protect the workpiece from slipping or
dropping by clamping it fast by means of
the screw clamp provided for this purpo-
se.
– Only switch the machine on if there is a
workpiece in machining position.
– Check the workpiece for foreign particles.
Do not cut into metal parts, for example
nails, as this might damage the sensitive
hard metal knifes.
– Do not machine any workpieces that are
too small or too big for the performance
range of the machine.
– On no account change the angle position
of the milling unit during an ongoing mil-
ling operation.
Information on maintenance and repair
– Before doing any maintenance or repair,
always unplug the connecting cable from
the socket at the machine, or switch off
the main switch and protect it from acci-
dental activation, for example by secu-
ring it with a padlock.
– Only use original MAFELL spares and
accessories. The manufacturer does not
accept any warranty claim and liability
beyond the above.
– Regular checks of the machine, in parti-
cular of the guides of the milling unit and
the smooth running of the protection cur-
tain, are of major importance.
– Careful maintenance of the milling tool is
significant as well. Keep it sharp and cle-
an to allow for safe operation and good
results. Observe the maintenance in-
structions and the notes for tool change.
– 31 –
Werbung
