KERN DS Betriebsanleitung Seite 98

10 Application <Weighing>
How to carry out a simple weighing and taring, please refer to chap. 8.2 or 8.4.
Further specific settings you will find in the following chapters.
Shouldn't the application <Weighing> already be enabled, select the menu
setting < mode  weig h >, see chap. 9
10.1 Application-specific settings
Call up menu:

Press the TARE key and hold it until< apcmen > is displayed.

The display changes to < wghmod > followed by < Ptare >.

Navigation in menu see chap. 13.1
Overview:
Level 1
Ptare
PRE-TARE
hold
Unit
Units
mode
Application mode
30
Level 2 Level 3
Take over the placed weight as PRE-TARE value,
actuAl
see chap. 10.2.1
Numerical input of the tare weight, see chap.
manuAl
10.2.2.
Delete PRE-TARE value
CLEAR
Start-Hold function, see chap. 10.2.3
-
available
This function defines in which weighing unit the
weighing units,
result will be displayed.
see chap. 1
Multiplication factor see chap. 10.2.5
FFA
Application unit counting
Pcs
Application unit for determining percentages
%
see chap. 10.2.4
Mol weighing mode, see chap. 10.2.6
mol
Weighing mode
weig h
Counting mode
count
Check mode
check
Description / Chapter
TDS-BA-def-2210
see chap. 9.