KERN DS Betriebsanleitung Seite 117



4. Start tolerance check:

Place the weighed material and check by means of the tolerance marks / acoustic
signal if the weighed material is within the defined tolerance.
Load below specified
tolerance
TDS-BA-def-2210

Use the navigation keys  to select setting < limlow >.

Press ➔ button to confirm, the numeric input window for
entering the lower limit value will appear. The active digit is
flashing.

Enter lower limit value (numerical input see chap. 3.2.2)
and confirm the entry.
The balance returns to the < limlow > menu.

Press repeatedly -button to exit menu.
Finished the setting works, the weighing balance will be ready
for checkweighing.
Load within specified
tolerance
Load exceeds specified
tolerance
49