Point-To-Point Path; Maintenance; Important Notes; Spare Parts - HellermannTyton Autotool System 3080 Montageanleitung

Step 6: The strap is cut off when the pre-set binding
strength is reached.
Step 7: The deflector advances.
Step 8: The ATS3080
5

5 .4 .1 Point-to-point path

Jaws Ø30 mm and
limiting block
Jaws Ø50 mm and
limiting block
Jaws Ø80 mm and
limiting block

6 Maintenance

6 .1 Important notes

Regular maintenance is essential to ensure that the
ATS3080 remains in safe working order (see the
maintenance schedule in the operating instructions for
the ATS3080).
CAUTION
Crush hazard when jaws close
f Do not insert fingers between upper and lower jaws.
f Do not rest your foot on the foot pedal.
f Always keep the Power pack 3080 switched off while
performing maintenance work.
f Depressurise the compressed-air system and secure
against unintentional restart.

6 .2 Spare parts

Spare parts and accessories can be ordered directly from
your national HellermannTyton representative
à website www.HellermannTyton.de.

6 .3 General maintenance activities

The activities involved in maintenance of the ATS3080 and
the Power pack 3080 are described in the operating
instructions for the ATS3080 (see the "Maintenance" section
in the operating instructions for the ATS3080).
f Check the ATS3080 and the accessories regularly for
proper function.
f Check the compressed-air lines for leaks (see the
operating instructions for the compressed-air
equipment).
The compressed-air equipment is not included in the scope
of supply.
f Changing the strap reel
f Replace faulty compressed-air lines immediately.
f Check electrical wiring for damage.
f Replace faulty wires immediately.
Assembly instructions Montagevorrichtung beweglich 3080 • 03-2017 • v02 • 102-01009
returns to the start position.
15 mm
(5 mm without
pressure)
15 mm
(5 mm without
pressure)
22 mm
(5 mm without
pressure)
6 .4

Changing the strap reel

1
9
8
7
6
5
f Push brake block
up.
1
f Push in sleeve of articulated shaft
9
inward.
f Remove the empty strap reel and dispose of it in
accordance with local regulations.
Empty reels are not taken back by the manufacturer.
f Insert full strap reel onto reel mount
2
coiling position in this process.
; Strap reel uncoils anti-clockwise.
2
; The collar of reel brake
7
Bench mount kit beweglich 3080.
f Feed strap around the deflection rollers to the
4
ATS3080 , à "Inserting the strap reel" on page 11.
6
The digits (1 and 2) on the deflection rollers indicate the
sequence for guidance of the strap, à label on the reel
mount.
f Make sure that strap
is not twisted.
4
f With the teeth facing up, introduce the end of strap
into the opening of the ATS3080
f Close latch on the ATS3080
5
; The red LED in the display goes out.
Maintenance
2
Po
we
r
Sig na
l
and tilt bearing
8
. Note the
3
holds strap reel on the
2
4
.
6
.
6
3
4
7
13