Adjusting Spikes; Connecting The Ats3080 And Bench Mount; Kit Movable 3080; Inserting The Bmk Closure Chain Guide - HellermannTyton Autotool System 3080 Montageanleitung

f Insert the screws and tighten.

5 .1 .5 Adjusting spikes

1
2
f Unscrew clamping screw
f Set spikes to the desired height for the material to be
1
bundled.
f Tighten clamping screw
5 .1 .6 Connecting the ATS3080 and Bench mount kit
beweglich 3080
1 2
5
4
To connect the ATS3080 and Power pack 3080,
observe the operating instructions for the ATS3080.
f Plug the connecting cable of the ATS3080
socket and at control box
2
socket , à "Connection plan" on page 18.
X4
f At control box , connect the foot pedal to socket
3
à "Connection plan" on page 18.
f Connect Power pack 3080
box and to the power supply, à "Interface overview,
3
Power pack 3080" on page 15.
f Connect compressed air connection
compressed air supply system.
Assembly instructions Montagevorrichtung beweglich 3080 • 03-2017 • v02 • 102-01009
.
2
.
2
Po we
r
Si gn
al
into
1
, connect the cable to
3
X1
to socket of control
5 X2
to the
4
f Make sure that all the wiring is free of kinks.
f Check that compressed air connection
leak-tight.
f Make sure that there is nothing to obstruct accessibility
to ATS3080 , Power pack 3080, control boxes and reel
5
holders.

5 .1 .7 Inserting the BMK closure chain guide

1
3
f Pull out locking pin
f Insert holder of closure chain guide
1
f Allow locking pin

5 .1 .8 Inserting the closure reel

1
8
7
3
6
f Remove closure reel
the protective mesh.
,
f Push in sleeve
6
inward.
f Insert closure reel
position in this process.
; The closure reel
1
Installation
is secure and
4
.
2
.
3
to lock firmly into place.
2
2
from its packaging and remove
1
of articulated shaft and tilt bearing
8
onto reel mount . Note the coiling
1 2
uncoils clockwise.
2
3
4
5
7
10