Raised Stand, Raised Seat - Palfinger PK 48000 Betriebsanleitung

4.3-6
4.3-6

Raised stand, raised seat

To climb up to the raised seat or raised stand the aids provided must be used (ladder, handles).
Make sure that you do not activate any controls when climbing up.
• The handles, steps and standing areas are to be kept free of dirt, oil and ice (danger of
slipping!). If necessary they are to be cleaned before climbing up.
• After entering the control stand the respective safety devices to prevent falling (belt, bar, rope)
must be used (closed, applied).
Raised stand slewing limiter
If your crane is equipped with a raised stand slewing limiter (see also 4.2-
3), the area over the control stand is blocked during crane operation from
the raised stand.
When working from the raised seat always ensure that there is
enough clearance between the raised seat and the load (see 1.3-
1).
When working on the raised stand ensure that you are never in
the danger area of the crane, in particular below the suspended
load or under or near moving crane components. While
performing crane movements therefore always keep the required
safe distance from the load and crane components. If this
distance is not maintained you will be in acute danger of fatal
injury!
Additional equipment