Scheppach SG2500i Originalbetriebsanleitung Seite 19

1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• improper handling,
• noncompliance of the operating instructions,
• repairs by third parties, not by authorized service
technicians,
• installation and replacement of non-original spare
parts,
• non-intended use,
We recommend:
That you read through the entire operating instruc-
tions before putting the machine into operation.
These operating instructions are to assist you in get-
ting to know your machine and utilize its proper ap-
plications.
The operating instructions contain important notes on
how you work with the machine safely, expertly, and
economically, and how you can avoid hazards, save
repair costs, reduce downtime and increase the relia-
bility and service life of the machine.
In addition to the safety requirements contained in
these operating instructions, you must be careful to
observe your country's applicable regulations.
The operating instructions must always be near the
machine. Put them in a plastic folder to protect them
from dirt and humidity. They must be read by every
operator before beginning work and observed con-
scientiously. Only persons who have been trained in
the use of the machine and have been informed of
the various dangers may work with the machine. The
required minimum age must be observed.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of identically
constructed devices.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1 - 3)
1. Carrying handle
2. Fuel tank cap with ventilation
3. On / Off switch with choke
4. Starter pull cord
5. Engine cover
6. Spark plug cover
7. Earthing connection
8. Energy saving switch
9. 230 V ~ - socket outlets (2x)
10. USB - port (2x)
11. Oil warning display
12. Overload display
13. Operating display
A Oil filler plug
B Air filter cover
C Air filter
D Spark plug
3. Scope of delivery
a. SG2500i
b. manual
c. spark plug wrench
d. funnel
4. Intended use
The device is designed for applications operated with
a 230 V alternating current source.
Be sure to observe the restrictions in the safety
instructions.
The generator is intended to provide electric power
tools and light sources with electricity. When using
the device with household appliances, please check
their suitability in accordance with the relevant manu-
facturer's instructions.
In case of doubt, ask an authorized dealer of the re-
spective equipment.
This generator is only intended for the operation of
electrical devices which maximum power lies within
the performance indications of the generator. A high-
er inrush current of inductive consumers must be
considered.
Inverter
The inverter generator generates electricity in a
whole new way. With a small, multipole winding in
the inside the produced voltage is converted via elec-
tronic first into DC voltage afterwards into alternating
voltage with a clean sinus wave. With this clean sinus
wave it is possible to operate electrical devices with-
out damaging them.
www.scheppach.com
GB | 19