Bosch MUMS6 Serie Gebrauchsanleitung Seite 40

en Basic settings
Process the ingredients until you
3.
achieve the required result.
Set the rotary switch to
4.
→ Fig. 14
Wait until the appliance stops.
Tip: You can change the speed at
any time during processing or inter-
rupt processing.
7.3 Using instantaneous
switching
Set the rotary switch to
1.
hold.
15
→ Fig.
a The ingredients are processed at
maximum speed.
Release the rotary switch.
2.
→ Fig. 16
a The rotary switch springs to
a Processing stops.
Tip: Instantaneous switching is espe-
cially suitable when using the glass
blender attachment.
7.4 Finishing processing
Unplug the mains plug.
1.
17
→ Fig.
Press the release button and raise
2.
the swivel arm until it engages.
→ Fig. 18
If the swivel arm does not open
3.
easily or there is a lot of dough on
the tool, proceed as follows:
Open up the swivel arm a bit
‒
and use a spatula or wooden
spoon to push the dough off the
tool.
Open the swivel arm right up, re-
‒
move the dough still remaining
on the tool and only then take
the tool off.
40
4.
⁠ .
5.
6.
Tip: Clean all parts immediately after
and
use so that residues do not dry on.
7.5 Using accessory drives
Notes
¡ Remove the cover to use ac-
¡ Always close unused drives with
⁠ .
¡ Please follow the instructions for
1.
2.
3.
4.
8 Basic settings
You can configure the basic settings
for your appliance to meet your
needs.
Press the ejector button to release
the tool and remove.
→ Fig. 19
Only ever press the ejector button
with the swivel arm open or the
tool may get jammed in the bowl.
Take the cover off the main drive.
→ Fig. 20
Turn the bowl clockwise and re-
move.
21
→ Fig.
cessories on drive 2 or 3.
the covers.
the accessory.
Lift the cover of drive 2 by the side
opening and remove.
→ Fig. 22
Fit the cover of drive 2 and press
down firmly.
23
→ Fig.
Turn the cover of drive 3 anticlock-
wise and remove.
24
→ Fig.
Fit the cover of drive 3 and secure
by turning clockwise.
→ Fig. 25