Setting Up The Device - VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung

Do not store lead accumulators next to heat sources or open fire.
Insulate its contacts by using an insulating tape and ensure a dry and
cold environment. Storage temperature: from -15°C to +40°C.
If you do not use lead-acid accumulators for a longer period of time,
recharge them approximately every 3 months to avoid their total
discharge.
Never short-circuit the battery contacts.
Before charging accumulators with liquid acid, open the inspection plugs of the
single cells.

Setting up the Device

Look for a suitable place close to a mains socket.
The charging station can be set up on a stable and horizontal surface.
IUse an appropriate base support to protect the surface of your furniture.
Softener-solvent substances contained in furniture preservatives could
etch the rubber feet of the charger which then in their turn could damage
your furniture.
With the CT-1500Pb, there are two eyelets for wall mounting to hooks on the back of
the device.
Connection
If a battery installed in a vehicle is charged, observe the following sequen-
ce of connection:
Disconnect the connection between the battery and the body.
The battery terminal (in most cases the positive terminal), which has not
been connected to the body, is to be connected first.
Now the battery terminal (mostly the negative terminal), which has been
connected to the body, is to be connected far from petrol lines.
Connect the mains plug of the charging station with a suitable mains
socket and turn on the device.
After the charging process the charging station will be separated from the power
supply: first disconnect the negative charging cable and then the positive one. Re-
connect the battery with the body.
31