VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 45

To the right to the percent indication, another battery symbol is displayed. This sym-
bol allows to draw a conclusion about the self-discharge of the accumulator. The
status of the accumulator will be determined after the end of the charging process
and again after another 5 hours. This means that the icon may still change after
charging is complete; in order to evaluate this icon, the accumulator has to stay con-
nected 5 hours after the end of the program.
- A full battery symbol points to a very low self-discharge. It shows that the accu-
mulator is in a very good condition in terms of self-discharge.
- Three bars indicate a beginning weakness of the accumulator.
- Two bars point to an increased self-discharge.
- If the battery symbol is empty, you should think about purchasing a new accumu-
lator as soon as possible.
Now, the accumulator can be disconnected.
If you do not disconnect the accumulator and the accumulator needs to be
recharged, the trickle charge programme TRICKLE (TRI) will be started automatical-
ly after 5 hours at the earliest; this means that the accumulator will be recharged. The
capacity (C) of the recharge (Trickle) and the time required for this process (hh:mm)
will not be indicated or summed up. Only the voltage and the current are always
updated. Therefore, the charging capacity, the discharging capacity and the time
only refer to the programme processed.
"TRI S>C= 34.29Ah
"08:51 D= 31.67Ah
"23° C U= 13.109V
"08:51:00 I= 0.500A "
If the recharging process has not been successful, the error message ERR (for
ERROR) is displayed and the charging station does not charge this accumulator any
longer.
"ERR C= 82.9mAh
"00:07:00 D=
"23° C U= 15.109V
"00:07:00 I=
If the temperature limits are exceeded or not reached during the process, the con-
cerned programme will be interrupted and TMP will be displayed for temperature.
TMP C= 17.4mAh
00:01 D= 0.0mAh
43° C U= 12.109V
00:01 I= 0.000A
"
"
"
"
0.0mAh"
"
0.000A"
45