VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 36

During this process, the first line indicates the charge programme (e.g. CHA for
CHARGE), an accumulator symbol for the charge status of the accumulator (in this
case indicated by an „S" for symbol) and the charging capacity. If a charge process
is currently running, an arrow flashes before „C".
The second line contains the type of the accumulator (St for standard accumulators,
GV for gel or fleece lead accumulators), the nominal accumulator voltage selected (6V
for an accumulator with 3 cells, 12V for 6 cells) and the discharging capacity. If a dis-
charge process is currently running, an arrow flashes before „D".
The second type of display indicates the temperature in the first line. Normally, it cor-
responds to the ambient temperature. In any case, this value is decisive for the turn-
ing off control, if the corresponding temperature limit is not reached or exceeded.
An arrow blinks next to it and the measured accumulator voltage is displayed. If
charging currently takes place, the arrow points upwards; during discharging, the
arrow points downwards.
If a voltage has not been ascertained yet, the following display appears
"23° C >U= -.---V"
The second line indicates the processing time in hh:mm which has already been
passed. If 100 hours are reached, the time will be set back to 00:00 (the WINTER pro-
gramme is almost the only one in which this may happen). The charging or discharge
current is also indicated. In the WINTER programme the passed waiting time is dis-
played as T=DAYS/hh:mm during the pause. Then, an arrow is flashing before „T".
"BREAK>T=29/23:59"
During operation, the OK, UP and DOWN buttons are only used for changing the dis-
play.
A running programme can only be interrupted by disconnecting the accumulator. If
the accumulator is disconnected during the charging or discharging process, it is
possible that the message ERR (for error) will briefly appear, because the device
detects that power is not supplied any longer. Afterwards, the stand-by indicator will
be displayed again.
If a programme has been successfully carried out, RDY (for READY) appears and the
arrow stops flashing.
"RDY S C= 3429mAh"
"St12V D= 3167mAh"
"23° C U= 13.242V"
"08:51:00 D = 96% S"
36