VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 43

Terminate a running program by pressing ESC and then pressing OK.
Then disconnect the accumulator.
Afterwards, you can connect the accumulator again and enter all parame-
ters anew.
You can cancel a running program by pressing ESC.
" PRESS <OK> TO
" STOP PROGRAM
If you now press the OK button, the current program is cancelled with an ERROR
(with the push of any other button, the program continues).
"ERR C= 82.9mAh
"00:03 D= 0.0mAh
The CHA, CYC, ALV and PSH program start with the charging process, whereas the
CHK and WIN programmes start with the discharging process.
All available data of the accumulator are displayed.
There are two display types provided. These two display types are selected via the
UP and DOWN keys. With the OK button pressed, the two displays are shown alter-
nately approx. every 4 seconds.
"CHA S>C= 17.4mAh
"00:01 D= 0.0mAh
"23° C >U= 12.109V
"00:01:00 I= 0.200A "
During this process, the first line indicates the charge programme (e.g. CHA for
CHARGE), an accumulator symbol for the charge status of the accumulator (in this
case indicated by an „S" for symbol) and the charging capacity. If a charge process
is currently running, an arrow flashes before „C".
The second line indicates the processing time in hh:mm which has already been
passed and the discharge capacity. If a discharge process is currently running, an
arrow flashes before „D".
The second type of display indicates the temperature in the first line. Normally, it cor-
responds to the ambient temperature. In any case, this value is decisive for the turn-
ing off control, if the corresponding temperature limit is not reached or exceeded.
"
"
"
"
"
"
"
43