Intended Use - VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung

Intended use

The CT-1500Pb is a fully automatic charging station for 6V and 12V lead accumula-
tors with temperature control and temperature-dependent final charging voltage.
The device is suited for accumulators with a capacity from 1Ah to 44Ah.
The CT-8000Pb is only intended for 12V lead accumulators with a capacity of 10Ah
to 200Ah.
All types of lead-acid accumulators (e.g. liquid, gel, fleece) can be charged, dis-
charged and maintained with these two charging stations.
Never use this device for charging or discharging dry batteries (primary cells), Ni-Cd,
Ni-MH, Li-ion or Li-polymer accumulators.
A double-line, illuminated display is integrated for easy operation. It simplifies the
menu assistance for the different modes of operation.
The following programmes are available:
- Charge (charging)
- Check (discharging / charging)
- Cycle (charging / discharging / charging)
- Alive ( charging/discharging twice / charging)
- Winter (simulated operation with adjustable pause)
Additional features of the CT-8000Pb:
- Push (1 minute charging with high current for refreshing accumulators)
After completing a program, the device automatically switches to trickle charge.
The determined accumulator data are shown on the display. This data is also main-
tained when the device is switched off or in case of a power failure as long as the
accumulator stays plugged in (memory backup).
The charging station is provided with a reverse battery protection and a short circuit
protection.
The minimum or maximum permissible environmental temperature of -15°C and
+40°C, respectively, may not decrease or be exceeded. In this case, the device goes
into break mode.
Do not operate the charging station if it is open or if some housing parts are missing.
The operation in moist rooms or outdoor or under adverse ambient conditions is not
permitted.
27